Tyan Transport VX50 (B4881) Drivers Download (2019)

Download Now
Tyan Transport VX50 (B4881) Driver

BV50S4H-8P TYAN The Transport VX50 (B) 8-way server platform supports up to eight AMD Opteron series single and dual core processors. Buy 4GB kit (2x2GB Modules) RAM Memory for Tyan Transport VX50 (B) (PC Reg) Server Memory & Workstation Memory Upgrade by US Seller. No information is available for this page.

Tyan Transport VX50 (B4881) Driver

Type: Driver
110 (4.15)
Downloads: 1149
File Size: 24.33Mb
Supported systems: ALL Windows 32x/64x
Price: Free* [*Free Registration Required]

Download Now
Tyan Transport VX50 (B4881) Driver

Memory modules will fit in the slot only one way.

Make sure that the memory module is firmly in place. When upgrading with a CPU expansion board, a further power supply module must be installed. Do not use excessive force to push the CPU expansion board into place.

Tyan Transport VX50 (B4881) Drivers Mac

When properly aligned, the board should slot into place easily. Secure in place with two screws as shown.

Tyan BIOS Transport VX50 (B4881) Free Driver Download (Official)

Insert two further coutersunk screws through the chassis to secure the expansion board to the chassis as shown. Installing Pci-x Cards 2. Remove a blanking plate from the rear panel of the chas- sis as shown.

Tyan Transport VX50 (B4881) Windows 8 X64

Installing A Storage Backplane 2. Fix the storage backplane to the drive housing using six screws.

Transport VX50 Service Engineer`s Manual

Press the drive housing release button and lower the drive housing back into place. Drive housing release button 6. Connect power and data cables to the backplane.

Press the release clip and pull the release lever to unlock the drive tray from the chassis. Installing Internal Hard Drives 2.

Transport VX50 Service Engineer`s Manual

Insert the drive tray back into the chassis and push the locking lever into place to secure it. Lift the drive housing to the vertical position as shown.

Slide the new drive into place until it locks. Drive housing release button 7. Remove the thin, center rail from each sliding rail set.

Tyan Transport VX50 (B4881) Drivers Update

Thin center rails are bolted to the VX50 B chassis. Bolt the assembled rail sets to the rack using M5L8-H3 screws and small rack mounting brackets supplied.


Small rack mounting bracket 4. Fit the rails directly behind the rack frame. The small rack mounting brackets should be against the rails as shown.

The rails should not be mounted in front of the rack frame. Use the top and bottom holes to fix the brackets to the rack frame. Bolt one of the thin, center sliding rails to each side of the server using M4L6-H2. Ensure that each rail is bolted on the right way round Tyan Transport VX50 (B4881) shown.

Tyan BIOS Transport VX50 (B) Free Driver Download (Official) - vx50_b_zip

Bolt the ears to the front of the server chassis using 8 flat head, M5L8 screws as shown. If available, wear a grounded wrist strap. Alternatively, discharge any static electricity by touching the bare metal chassis of the unit case, or the Tyan Transport VX50 (B4881) metal body of any other grounded appliance. Avoid touching motherboard components, IC chips, connectors, memory modules, or leads.

The motherboard is pre-installed in the system.

TYAN Transport VX50 Service Manual

When removing the motherboard, always place it on a grounded anti-static surface until you are ready to reinstall it. Hold electronic circuit boards by the edges only. Do not touch the components on the board unless it is necessary to do so. Do not flex or stress circuit Tyan Transport VX50 (B4881).

Related Drivers